3D chocolate mold Piguin, 4 pieces

3D chocolate mold Piguin, 4 pieces

With the 3D Piguin chocolate mold, you can make four small 3D penguins in no time at all. Ideal as a gift for the festive season. The chocolate mold is hard-wearing and can be used over 100 times with the right care. This mold is suitable for casting detailed hollow figures from tempered couverture in uniform quality. The mold can be easily cleaned with lukewarm water and mild detergent without lye/shine rinse. Then dry well, hold the edges and polish with lint-free absorbent cotton. It is best to use high-quality couverture that you temper (with a tempering device or a water bath). Add color accents with colored cocoa butter or tempered couverture. Always use clean, dry and grease-free tools and wear gloves when working. After a short drying time, the entire mold can be brushed out. Make sure that you avoid air bubbles. Clean the edges with the metal horn. You can secure the two halves with the clips provided. Then fill the mold. Allow any excess mixture to run out and repeat the process if necessary until the wall thickness is right. Leave the mixture to cool for 2-5 minutes. Spread a base on baking paper so that you can press the cooled mold onto it. Leave the mold to cool for another 10-15 minutes. You can now remove the clips. Finally, break off the excess base and carefully remove the figure from the mold.